Filter
Top Products
26
NO DIAL TONE
• Verify the TALK Button is lit.
• Verify the AC adapter is securely plugged into the AC
power outlet and the telephone.
• Verify the telephone line cord is securely plugged into the
wall jack and the telephone.
• Make sure the handset batteries are fully charged.
• Verify the telephone is in the correct dialing mode, tone
(touch) or pulse (rotary).
• Make sure you are in the usable range of the base station.
• You may have too many extensions on your line. Try
unplugging a few devices.
NO DIAL TONE, AND HANDSET VISUAL
RINGER is blinking (twice every second)
It is possible that the handset has lost connection to the
base.
• Make sure you are in the usable range of the base station.
• If you are close to the base, but you are still unable to
get a dial tone, proceed as follows:
1. Handset: press and hold the FLASH button for three
seconds, until the keypad backlight and visual ringer start
ashing; release the FLASH button.
2. Base: press and hold the FIND button for three
seconds, until the IN USE light and visual ringer (base)
start ashing; release the FIND button.
3. Wait for the connection to be re-established; the handset
will beep ve times to indicate successful registration.
4. If the handset beeps just twice, the registration was not
successful. Repeat steps 1-4 above.
Troubleshooting
XLC2