Filter
Top Products
8
Connect your telephone as shown on the enclosed Quick
Start guide.
Your telephone should arrive pre-assembled. To install it:
1. Remove base from package; pull yellow tab in the
direction of the arrow.
2. Hold one end of the long phone line cord tightly. The
correct end to hold should already be plugged into
your phone’s jack. Simultaneously pull the other end of
the phone cord away from the phone, unraveling it and
allowing you to plug that end of the cord into a wall
telephone outlet.
3. Plug the loose end of the phone cord into the wall
telephone outlet.
4. Hold one end of your phone’s white power adapter cord
tightly. The correct end to hold should already be plugged
into the back of your telephone base unit. Simultaneously
pull the other end of the adapter cord away from the
phone, unraveling it and allowing you to plug that end of
the cord into a wall electrical outlet.
5. Plug white power adapter cord on left rear of the base
into a wall electrical outlet.
6. Remove handset from package.
7. Pull the handset’s battery tab located on the bottom of
the device in the direction of the arrow.
8. Place the handset in the base charger. The batteries in
the handset must be fully charged for 10 hours before
using the telephone for the rst time.
9. Lift handset and press TALK to test. If you hear a dial
tone, your telephone is ready for use. If not, check all
connections again.
Installation
XLC2