Filter
Top Products
14
4
Start the wash-cycle by pressing the Start button (S) and releasing it immedi-
ately. The door is sealed and the cycle-LED lights up.
During the fi rst 2 minutes after starting, the program number is blinking and
you can change the program in case of a possibly wrong selection.
To do so, select another program with the SELECT button (P). This new
program will start immediately.
Start the machine
Display information
The left display will indicate the temperature of the wash bath - in °C or °F
(on machines where this function has been selected).
Indications of program
sequence
The central display shows the remaining time to the end of the wash cycle.
For programs which are being run for the fi rst time, the machine will take a
theoretical time estimate. If this time indication does not correspond to the real
cycle time, the cycle time will be corrected from the second cycle onwards
(Self-Teaching function of the machine).
This correction will have to be preprogrammed and is not activated on program
numbers higher than 20. The corrected time will also be lost when the power
has been cut from the machine for more than 24 hours.
The right display will continue to show the selected program number.
If a Level-stop was programmed (which halts the programmer during the fi lling
of the cylinder) and/or a Heat-stop (which stops the programmer during the
heating up of the wash bath, then the respective LED’s light up in the display.
Once the required water level and/or temperature have been reached, the LED
is turned off and the internal programmer advances again.
Wash cycle-LED’s
Each program segment has a corresponding LED. Each of these 6 LED’s light
up when the appropriate segment is executed. This way, the program sequence
can be accurately followed.
When a LED blinks, the machine is taking up water.
When a LED blinks slowly, the machine is heating up the water.
Spin-LED’s
When the water is drained at the at the end of a program segment and the
machine spins if so desired, the left spin-LED (intermediate spin) will light
up together with the cycle-LED.
LED drain/distribution low spin coast
Interm. spin blinking rapidly continuously continuously
- Functioning of the spin-LED’s during gentle-intermediate spin:
LED drain/distribution low spin coast
Interm. spin blinking rapidly blinking slowly blinking slowly
- Functioning of the spin-LED’s during intermediate spin: