Filter
Top Products
bühler
Allied Front-End Loader
- 20 - P4094
2. Lower attachment level to the ground
while engaging float position. Ensure
attachment rests firmly on ground with minimal
downward pressure. If required extend bucket
cylinders to rotate upright rearward. At this
stage the pin should have no pressure. Set
tractor park brake and remove loader lock
pins. Check hydraulic hoses such that they
will not get pinched or stretched during
removal.
WARNING Operate hydraulic controls slowly. Loader will
disengage from the mounting kit and may shift if not on firm level ground.
3. Retract bucket cylinders to raise upright
and disengage from the loader mount cradle.
If additional clearance is required, extend lift
cylinders while slowly backing the tractor
away from the loader.
4. After the tractor is clear of the loader,
retract all cylinders to protect the shafting.
Shut tractor off and set park brake and
relieve oil pressure in hoses by moving valve
control. Disconnect hydraulic loader
hydraulic hoses at the quick couplers.
IMPORTANT: Cap both male and female
couplers. Wrap loader hoses over loader
arm.