Filter
Top Products
The program will continue
to
the end, when the
"End" indicator lamp will become illuminated. And
if the "End
of
Cycle Signal" has been selected a
signal will sound.
Note: If the load
is
not removed, the drum will, for
the following 35 minutes, rotate at brief
intervals
to
prevent wrinkling (Anti-Crease).
After 35 minutes this feature will cease its
function.
It
is recommended that the dryer
be unloaded
no
later than 35 minutes after
completion of program to avoid wrinkling.
7.
Select ADDITIONAL FUNCTIONS,
if
desired
The additional functions available are accessible
by depressing the buttons:
"DELICATES"
The "DELICATES" button, see Figure
5,
will
reduce the drying temperature and lengthen the
drying time when depressed. It is recommended
that the "DELICATES" button
be
depressed when
drying heat sensitive fabrics, such as, acrylics. Be
sure to follow the instructions listed on the care
label instructions.
"END
OF
CYCLE SIGNAL"
When the "END of CYCLE SIGNAL" button, see
Figure
5,
is activated there will be a signal
sounded at regular intervals at completion of the
selected program.
The volume level
of
the sound may be changed by
holding the button
in
until desired volume level is
reached. This volume level will
be
stored for future
use until altered.
The end
of
cycle signal can be switched off by
depressing the button again. The indicator light
above the button will turn off
to
indicate that the
signal is no longer selected.
0ryInQ
Damp
DI)'
o 0
~~
~
c=::::z=)
Figure
5.
R<9ula,
DI)'
Extra
Dry
Anti-Crease/End
000
I
O
Start
I
Deli-
I
End
Df
Cycle
cales
Signal
o 0
c:=:=::=> c::::;::::::::: c::::z::::::>
~~~
Cycle
Counldown
<9
I
Cycle
TIme
Minutes
o
=
=
8
8.
Press
the
"START"
Button
Depress the "START" button. The indicator light
above the "START" button will become illuminated
and the machine will start. If one of the Auto
Cycles has been selected the Duotronic system
will continuously monitor the moisture level of the
load and display the progress
in
the "Moisture
Level Indicator Lights." If a timed cycle has been
selected, either Heated Dry or Air Fluff, the
minutes remaining
in
the program will
be
shown in
the "Cycle Countdown Display."
9.
Depress the "DOOR" button
The door will open.
10. Remove the Laundry from the Dryer
11.
Clean the Lint Filter
The lint filter, located
in
the door, should
be
cleaned after each load. Cleaning the filter will
shorten drying times and save energy.
12. Turn Off the Dryer.
Depress the "ON/OFF" button.