Filter
Top Products
3.
Load
the
dryer
For best results it is recommended that the drying
load be sorted by fabric type and desired dryness
level. Also, close all zippers, hooks and eyelets
and tie loose belts and apron strings, etc. before
placing in the dryer.
a. Depress the "DOOR" button. The door will open
and the drum light will turn on.
b.
Check the drum interior for foreign objects
or
pets and remove any used fabric softener
sheets.
c.
Place laundry items to be dried loosely into the
drum
of
the dryer.
Timed
Cycles
0(9
Heated
Dry
o
Air
Fluff
o
Permanent
0 .Regular/Cott.
Press
0
Extra
Dry
o
Very
Dry
•
Regular
Dry
o
Light
Dry
o
Econo
Dry
o
Damp
Dry
4.
Add
Fabric
Softener
Sheet, if
desired
If a fabric softener sheet is to be added it should
be done after loading the dryer and before the
dryer and load become warm. This will prevent
greasy-looking softener stains.
5.
Close
the
Door
Check the area around the drum opening to make
sure that nothing is caught on the edge
or
hanging
outside the drum and close the door making sure
the door clicks into place and is fully closed.
Figure
3.
b.
To
use
Time
Cyles
(dryer runs for selected
length
of
time) activate by turning the time
program selector (see Figure 4):
i.
Heated
Dry
The Time Cycle's knob should be turned to
point to the right to select the Heated Dry
setting. Then depress the "Cycle Time
Minutes" button to set the time interval for
drying. The time can be set at
10 -
90
minutes in
10
minute steps.
or,
Note: The Auto-Program knob must be
pointing straight-up to use Time Cycles.
ii.
Air
Fluff
(cold)
The Time Cycle's knob should be turned to
point the left to select the Air Fluff setting.
Then depress the "Cycle Time Minutes"
button to set the time interval for drying. The
time can be set at
10
-
90
minutes in
10
minute steps.
,
aD
Permanent
0 0
Regular/Cotl.
Press
0
Extra
Dry
o
Very
Dry
o
Regular
Dry
o
Light
Dry
o
Econo
Dry
o
Damp
Dry
TImed
Cycles
.<.9
Heated
Dry
•
Air
Fluff
o
UntFilter
o
Cycle
Countdown
t.'iDO.i
.•.
J
<.9
:.~.:r1,
'!:::
=
=
I
Cycle
TIme
Minutes
•
Note:
If the door is not fully closed the dryer will
not operate.
6.
Select
the
Drying
Cycle
Desired
The Bosch dryers can be operated
in
either the
Electronic Auto Dry Cycle mode, which uses the
Duotronic moisture sensing system,
or
in Time
Cycle mode, which uses a timer to control the
length
of
the program. See below and CYCLE
SELECTION CHART, Table
1,
for program
recommendations:
a.
To
use
Electronic
Auto
Dry
Cycles
(dryer runs until the drying level selected has
been reached) activate by turning the Cycle
Selector knob (see Figure 3) to:
i.
Regular
/Cott.
The
Auto-Program dial should be turned to
point to the right to select Regular/Cott.
settings. As the knob is turned the lights
directly above the knob will illuminate to
indicate the level
of
dryness selected, from
Extra Dry through Damp Dry. See Table
1
for recommended settings for type
of
load
being dried.
or,
ii.
Permanent
Press
The Auto-Program knob should be turned to
point to the left to select Permanent Press
settings. As the knob is turned the lights
directly above the knob will illuminate to
indicate the level
of
dryness selected. See
Table 1 for recommended settings for type
of
load being dried.
Figure
4.
7