Filter
Top Products
WFL 2060 Service Tips
WFL 2060 Service Tips
--
--
Resistance
Resistance
Measurements from Control Module (2)
Measurements from Control Module (2)
70
1
1
1
1
1
1
Disconnect & measure white 3-
pin connector (with blue wires)
to measure door latch motor.
Measure between pins 1-2 (pin 1
at far left). Motor should read ~
500 - 1500 Ω.
Pink
connector
with pink
wires
Black connector
with pink wire
Disconnect & measure white 6-pin connector
(with blue wires) to measure drum drive motor.
Motor should read (pin 1 is at far right):
• Pins 1-2: 14 - 35 Ω
• Pins 3-4: 1.5 - 10 Ω
• Pins 5-6: 0.7 - 2.1 Ω
1
1
Disconnect & measure 2 connectors to measure heater. Measure
between pin 1 (far left connector in group of 7 pins) and pin 2 (2nd pin from
right) of pressure switch connector. Heater should read 23.2 - 29.4 Ω.
WARNING! Unplug washer before making any resistance measurements.
1st Edition/Revision 5 (1/20/04)