Blomberg WNF 7361 SCE20 Washer User Manual


  Open as PDF
of 68
 
16
EN
7 Troubleshooting
Programme cannot be started or selected.
• Washingmachinehasswitchedtoselfprotectionmodeduetoasupplyproblem(linevoltage,waterpressure,
etc.).>>>Tocanceltheprogramme,turntheProgrammeSelectionknobtoselectanotherprogramme.Previous
programme will be cancelled. (See "Canceling the programme")
Water in the machine.
• Somewatermighthaveremainedintheproductduetothequalitycontrolprocessesintheproduction.>>>This is
not a failure; water is not harmful to the machine.
Machine vibrates or makes noise.
• Machinemightbestandingunbalanced.>>>Adjust the feet to level the machine.
• Ahardsubstancemighthaveenteredintothepumpfilter.>>>Clean the pump filter.
• Transportationsafetyboltsarenotremoved.>>>Remove the transportation safety bolts.
• Laundryquantityinthemachinemightbetoolittle.>>>Add more laundry to the machine.
• Machinemightbeoverloadedwithlaundry.>>>Take out some of the laundry from the machine or distribute the load by
hand to balance it homogenously in the machine.
• Machinemightbeleaningonarigiditem.>>>Make sure that the machine is not leaning on anything.
Machine stopped shortly after the programme started.
• Machinemighthavestoppedtemporarilyduetolowvoltage.>>>It will resume running when the voltage restores to the
normal level.
Programme time does not countdown. (On models with display)
• Timermaystopduringwaterintake.>>>Timer indicator will not countdown until the machine takes in adequate amount
of water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer
indicator will resume countdown after this.
• Timermaystopduringheatingstep.>>>Timer indicator will not countdown until the machine reaches the selected
temperature.
• Timermaystopduringspinningstep.>>>Automatic unbalanced load detection system might be activated due to the
unbalanced distribution of the laundry in the drum.
C
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any
damagetothemachineandtoitssurroundingenvironment.Laundryshouldberearrangedandre-spun.
Foam is overflowing from the detergent drawer.
• Toomuchdetergentisused.>>>Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of
the detergent drawer.
C
Put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme and
consumption table”. When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of
detergent.
Laundryremainswetattheendoftheprogramme
• Excessivefoammighthaveoccurredandautomaticfoamabsorptionsystemmighthavebeenactivatedduetotoo
muchdetergentusage.>>>Use recommended amount of detergent.
C
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any
damagetothemachineandtoitssurroundingenvironment.Laundryshouldberearrangedandre-spun.
A
Ifyoucannoteliminatetheproblemalthoughyoufollowtheinstructionsinthissection,consultyourdealerorthe
Authorized Service Agent. Never try to repair a nonfunctional product yourself.
2820522231_EN/080212.0916
 previous next