Blomberg WNF 5100 WE Washer User Manual


  Open as PDF
of 62
 
4
EN
• Topreventflowingofdirtywaterbackintothe
machine and to allow for easy discharge, do
not immerse the hose end into the dirty water or
driveitinthedrainmorethan15cm.Ifitistoo
long, cut it short.
• Theendofthehoseshouldnotbebent,it
shouldnotbesteppedonandthehosemust
notbepinchedbetweenthedrainandthe
machine.
• Ifthelengthofthehoseistooshort,useitby
adding an original extension hose. Length of the
hosemaynotbelongerthan3.2m.Toavoid
waterleakfailures,theconnectionbetween
the extension hose and the drain hose of the
productmustbefittedwellwithanappropriate
clamp as not to come off and leak.
Adjusting the feet
A
 Inordertoensurethattheproductoperates
moresilentandvibration-free,itmuststandlevel
andbalancedonitsfeet.Balancethemachine
byadjustingthefeet.Otherwise,theproduct
may move from its place and cause crushing
andvibrationproblems.
1. Loosenthelocknutsonthefeetbyhand.
2. Adjust the feet until the product stands level and
balanced.
3. Tightenalllocknutsagainbyhand.
A
 Donotuseanytoolstoloosenthelocknuts.
Otherwise,theywillgetdamaged.
Electrical connection
Connect the product to a grounded outlet protected
byafusecomplyingwiththevaluesinthe"Technical
specifications"table.Ourcompanyshallnotbeliable
for any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connectionmustcomplywithnational
regulations.
• Powercableplugmustbewithineasyreach
after installation.
• Thevoltageandallowedfuseorbreaker
protection are specified in the “Technical
specifications”section.Ifthecurrentvalueof
thefuseorbreakerinthehouseislessthan16
Amps,haveaqualifiedelectricianinstalla16
Amp fuse.
• Thespecifiedvoltagemustbeequaltoyour
mains voltage.
• Donotmakeconnectionsviaextensioncables
ormulti-plugs.
B
 Damagedpowercablesmustbereplacedby
the Authorized Service Agents.
First use
Beforestartingtousetheproduct,makesurethat
all preparations are made in accordance with the
instructionsinsections"Importantsafetyinstructions"
and"Installation".
To prepare the product for washing laundry, perform
firstoperationinDrumCleaningprogramme.If
yourmachineisnotfeaturedwithDrumCleaning
programme,useCottons-90programmeandselect
Additional Water or Extra Rinse auxiliary functions
aswell.Beforestartingtheprogramme,putmax.
100gofpowderanti-limescaleintothemainwash
detergentcompartment(compartmentnr.II).Ifthe
anti-limescaleisintabletform,putonlyonetabletinto
compartmentnr.II.Drytheinsideofthebellowwitha
clean piece of cloth after the programme has come
to an end.
C
Useananti-limescalesuitableforthewashing
machines.
C
Some water might have remained in the product
duetothequalitycontrolprocessesinthe
production.Itisnotharmfulfortheproduct.
Disposing of packaging material
Packaging materials are dangerous to children. Keep
packaging materials in a safe place away from reach
of the children.
Packaging materials of the product are manufactured
fromrecyclablematerials.Disposeofthemproperly
and sort in accordance with recycled waste
instructions.Donotdisposeofthemwithnormal
domestic waste.
Transportation of the product
Unplugtheproductbeforetransportingit.Remove
waterdrainandwatersupplyconnections.Drain
the remaining water in the product completely; see,
"Drainingremainingwaterandcleaningthepump
filter".Installtransportationsafetyboltsinthereverse
order of removal procedure; see, "Removing the
transportation locks".
 previous next