Blomberg WNF9422SC20 Washer/Dryer User Manual


 
16 - EN
Pull the emergency draining hose out from
its seat Place a large container at the end of
thehose.Drainthewaterintothecontainer
bypullingouttheplugattheendofthehose.
Whenthecontainerisfull,blocktheinletofthe
hosebyreplacingtheplug.Afterthecontainer
isemptied,repeattheaboveproceduretodrain
the water in the machine completely. When
drainingofwaterisfinished,closetheendby
the plug again and fix the hose in its place. Turn
the pump filter to take it out.
Dischargingthewaterwhentheproductdoes
not have an emergency draining hose:
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill
the flowing water into the container you have
placed in front of the filter. Always keep a piece
ofclothhandytoabsorbanyspilledwater.
When the water inside the machine is finished,
takeoutthefiltercompletelybyturningit.Clean
anyresiduesinsidethefilteraswellasfibers,
ifany,aroundthepumpimpellerregion.Install
the filter.
A
Ifyourproducthasawaterjetfeature,be
sure to fit the filter into its housing in the
pump.Neverforcethefilterwhileinstalling
it into its housing. Seat the filter into its
place completely. Otherwise, water may
leak from the filter cap.
Ifthefiltercapiscomposedoftwopieces,
closethefiltercapbypressingonthetab.Ifit
isonepiece,seatthetabsinthelowerpartinto
their places first, and then press the upper part
to close.