Filter
Top Products
EN
51
Auxiliary functions
Auxiliary Function Selection Buttons
Select the required auxiliary functions
before starting the Programme.
C
Some combinations cannot be
selected together. (Ex.: Pre-wash
and Quick Wash.
Warning signal on the selected auxiliary
function will light up.
Auxiliary function selection
If an auxiliary function that should not
be selected together with a previously
selected function is chosen, the first
selected function will be cancelled and
the last auxiliary function selection will
remain active.
(Ex.: If you want to select pre-wash first
and then quick wash, pre-wash will be
cancelled and quick wash will remain
active.
Auxiliary function that is not compatible
with the Programme cannot be
selected. (see, “Programme Selection
Table”)
C
Auxiliary function buttons may differ
according to the model of your
machine.
• Prewash
A pre-wash is only worthwhile for heavily
soiled laundry. Without pre-wash you
save energy, water, detergent and time.
C
Pre-wash without detergent is
recommended for lace and curtains.
• Quick Wash
This function can be used for “Cottons”
and “Synthetics” Programmes. It
decreases the washing times for lightly
soiled laundries and also the number of
rinsing steps.
• Rinse Plus
With this function, you can increase the
number of current rinsing steps. Thus,
sensitive skins’ risk of being affected by
the remainder detergent on the clothes
will be decreased.
• Anti-Creasing
With this function, drum movement will
be lessened to prevent creasing and
spinning speed is limited. In addition,
washing is carried out at a higher water
level.
C
Use this function for delicate
laundries that crease easily.
C
Whenever you select this auxiliary
function, load your machine with half
of the maximum laundry specified in
the Programme table.
• No Heat
If you wish to wash your clothes in cold
water, you can use this Programme.
Time display
The display shows the time remaining
for the Programme to complete while a
Programme is running. Time is displayed
in hours and minutes as “01:30”.
C
Programme duration may differ
from the values in the consumption
table subject to the changes in the
water pressure, water hardness and
temperature, ambient temperature,
type and amount of laundry, auxiliary
functions selected, and changes in
the supply voltage.
Time delay
With the “Time delay” function you can
delay the Programme start up to 24
hours. Time delay can be set with steps
of one hour for the first three hours
and with steps of three hours for the
remainder (1, 2, 3, 6, 9, …24).
C
Do not use liquid detergent when
you set time delay! There is the risk
of staining of the clothes.
1. Open the loading door, place the
laundry inside and fill detergent drawer.
2. Set the washing Programme, spin
speed and, if required, select the
auxiliary functions.
3. Pres “Time Delay” button to adjust
the desired time.
4. Press “Start/Pause/Cancel” button.
The time delay will start to count down.
The “:” in the middle of the displayed
time delay will start flashing.
C
More laundry may be loaded during
the time delay period.
5. At the end of countdown process, “:”
will light up continuously, “Ready” light