Blomberg WMT 7310 S Washer User Manual


 
EN
39
A
Ensure that the cold and hot water
connections are made correctly
when installing the product.
Otherwise, your laundry will come
out hot at the end of the washing
process and wear out.
2. Tighten all hose nuts by hand. Never
use a wrench when tightening the
nuts.
3. Open the taps completely after
making the hose connection
to check for water leaks at the
connection points. If any leaks
occur, turn off the tap and remove
the nut. Retighten the nut carefully
after checking the seal. To prevent
water leakages and damages
caused by them, keep the taps
closed when the machine is not in
use.
Connecting to the drain
The end of the drain hose
must be directly connected to
the wastewater drain or to the
washbasin.
A
Your house will be flooded if the
hose comes out of its housing
during water discharge. Moreover,
there is risk of scalding due to high
washing temperatures! To prevent
such situations and to ensure
smooth water intake and discharge
of the machine, fix the end of the
discharge hose tightly so that it
cannot come out.
The hose should be attached to a
height of at least 40 cm, and 100
cm at most.
In case the hose is elevated after
laying it on the floor level or close
to the ground (less than 40 cm
above the ground), water discharge
becomes more difficult and the
laundry may come out excessively
wet. Therefore, follow the heights
described in the figure.
To prevent flowing of dirty water
back into the machine and to allow
for easy discharge, do not immerse
the hose end into the dirty water or
drive it in the drain more than 15
cm. If it is too long, cut it short.
The end of the hose should not be
bent, it should not be stepped on
and the hose must not be pinched
between the drain and the machine.
If the length of the hose is too
short, use it by adding an original
extension hose. Length of the
hose may not be longer than 3.2
m. To avoid water leak failures, the
connection between the extension
hose and the drain hose of the
product must be fitted well with an
appropriate clamp as not to come
off and leak.