Filter
Top Products
17 - EN
1 Carefully remove the water tank by opening
the kick plate cover/pulling the drawer.
2 Drain the water by opening the water tank
cover.
3 If there is lint accumulation in the water
tank cover, clean it and press to close.
4 Place the water tank into its seat.
Condenser (products equipped with a
condenser)
Hot and humid air in the condenser is cooled
with the cold air from the room. Thus, the humid
air circulating in your machine is condensed and
then pumped into the tank.
C Clean the condenser after every 15 drying
cycles or once a month.
To clean the condenser;
1 If a drying process has been carried out,
open the door of the machine and wait
until it cools down.
2 Unlock the 4 condenser locks after
opening the kick plate.
3 Pull out the condenser.
4 Clean the condenser with pressurized
water and wait until the water drains.
5 Replace the condenser with the side
labeled “Top” facing upwards. Lock the 4
condenser locks. Make sure that the red
lock on the upper right corner is engaged
securely.
6 Close the kick plate cover.
Close properly and
check the locking
latchs?