Filter
Top Products
16 - EN
5 Maintenance and cleaning
Filter Cartridge / Door Inner Surface
Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
“Filter Cartridge”.
C Such fibre and lint are generally formed
during wearing and washing.
C Always clean the filter and the inner
surfaces of the cover after each drying
process.
C You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by
hand or with a soft piece of cloth. 4.
Close the filter and place it back into its
seat.
C Clogging may arise on the filter surface
after using your machine for some time; if
this occurs, wash the filter with water and
dry it before using again.
C Clean the entire inner surface of the cover
and door gasket.
.Sensor (models equipped with a sensor)
There are humidity sensors in your machine
that detect whether the laundry is dry or not.
For sensor cleaning;
1. Open the door of the machine.
2. Allow the machine to cool off if drying has
been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C Clean metal sensors 4 times a year.
A Never use solvents, cleaning agents or
substances alike when cleaning as these
might cause fire and explosion!
Water tank (Products equipped with a
condenser);
The moisture in the damp laundry is taken from
the laundry and condensed. Drain the water
tank after each drying cycle or during drying
when “Water tank” warning LED comes on.
A Condensed water is not drinkable!
C You can use the water in the water tank in
your steam irons or air humidifiers.
A Never take out the water tank when the
programme is running!
Water tank may be located in two different
places as indicated below, depending on the
model of your machine.
- Inside the drawer on the panel
- Inside the kick plate cover
If you forget to drain the water tank, your
machine will stop during the following drying
cycles when the water tank is full and the
“Water tank” warning LED will light on. If this
is the case, press the “Start/Pause/Cancel”
button to resume the drying cycle after draining
the water tank.
In order to drain the water tank;