7 - EN
C Exhaust of humid air from the dryer
into the room is inconvenient. It may
damage the walls and furniture in the
room.
C The ventilation hose can be routed
outdoors via a window or it can be
connected to the air outlet in the
bathroom.
C Air outlet hose must be extended
directly to the outdoors. There must
be a small number of elbows as not to
hinder air ventilation.
C To prevent water accumulation in the
hose, make sure that it is not folded
on the floor.
B The air ventilation hose should not be
connected to the chimney of a stove
or a fireplace.
B Do not operate your machine at the
same time with heaters such as a coal
or gas stove. Airflow may cause the
chimney to flare up. Airflow may cause
the chimney to flame up.
Connection to a water drain
(for products equipped with a
condenser and heat pump)
In products equipped with a condenser
unit the water accumulated during the
drying cycle is collected in the water tank.
Youshoulddraintheaccumulatedwater
after each washing cycle.
Youcandirectlysendtheaccumulated
water out through the water drain hose
supplied with the machine instead of
periodically draining the water collected in
the water tank.
Connecting the water drain hose;
1. Remove the hose on the machine by
pulling it out from its end. Do not use
any tools to take out the hose.
2. Connect the special drain hose
supplied with the machine to the pipe
fitting.
3. The other end of the drain hose
can be directly connected to the
wastewater drain or to the washbasin.
The fitting must always be secured in
alltypesofconnections.Yourhouse
may be flooded if the hose gets out of
its housing during water discharge.
C When you direct the water drain out,
“WaterTank”warningLEDwilllightup
at the end of each program.
Important:
• Thehoseshouldbeattachedtoa
height of maximum 80 cm.
• Youmustbecarefulnotthepinchor
bend the hose.
• Theendofthehoseshouldnotbe
bent, it should not be stepped on and
it must not be folded between the
drain and the machine.
Electrical connection
Connect the machine to an earthed outlet
protected by a fuse of suitable capacity.
Important:
• Connectionshouldcomplywith
national regulations.
• Powercordplugmustbewithineasy
reach after installation.
• Thevoltageandtheallowedfuse
protection are specified in the section
“TechnicalSpecifications”.