Beko WTL95019W Washer User Manual


 
12 / EN
Washing Machine /User’s Manual
Installation
3.5 Electrical connection
Connect the product to a grounded outlet
protected by a 6 A fuse. Our company shall not
be liable for any damages that will arise when the
product is used without grounding in accordance
with the local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker in
the house is less than 6 Amps, have a qualified
electrician install a 6 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
• Do not make connections via extension cables
or multi-plugs.
B
WARNING: Damaged power cables
must be replaced by the Authorized
Service Agents.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply
connections.
3. Drain all water that has remained in the
product.
4. Install all styrofoams and then pcakage the
machine.
A
WARNING: Packaging materials are
dangerous to children. Keep packaging
materials in a safe place away from
reach of the children.
3.6 Connection of inlet hose
connector and tap
1. Tighten all hose nuts by hand. Never use a tool
when tightening the nuts.
2. Open the taps completely after making the
hose connection to check for water leaks at
the connection points. If any leaks occur, turn
off the tap and remove the nut. Retighten the
nut carefully after checking the seal. To prevent
water leakages and damages caused by them,
keep the taps closed when the machine is not
in use.