Filter
Top Products
Washing Machine /User’s Manual
11 / EN
Installation
3.3.2 Connecting to the drain with pump
• The hose should be attached to a height of at
least 40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on
the floor level or close to the ground (less than
40 cm above the ground), water discharge
becomes more difficult and the laundry may
come out excessively wet. Therefore, follow the
heights described in the figure.
• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do
not drive it in the drain more than 15 cm. If it is
too long, cut it short.
• The end of the hose should not be bent, it
should not be stepped on and the hose must
not be pinched between the drain and the
machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.
3.4 Adjusting the feet
• The two front feet of washing machine can
adjust the positive, when the washing machine
is not level, you can up the front of washing
machine for a little, then left or right rotation to
adjustable the feet, make it level.You can check
the level by the help of the indicator on top
cover.
Adjusting foot by checking leveler.
• Remarking : there may be no leveler for some
types machine.