Beko WTL11019W Washer User Manual


 
Maintenance and cleaning
6.4 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
washing water. Thus, the water will be discharged
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house) and in case
of freezing of the water, water may have to be
drained completely.
WARNING: Foreign substances left
in the pump filter may damage your
machine or may cause noise problem.
In order to clean the dirty filter and discharge
the water:
1. Unplug the machine to cut off the supply power.
2. Open the filter cap.
Press the tab on the filter cap to the left side
and pull the cover out towards yourself.
a. Place a large container in front of the filter to
catch water from the filter.
b. Loosen pump filter (anticlockwise) until water
starts to flow. Fill the flowing water into the
container you have placed in front of the filter.
Always keep a piece of cloth handy to absorb
any spilled water.
c. When the water inside the machine is finished,
take out the filter completely by turning it.
4. Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
5. Install the filter.
Washing Machine /User’s Manual
25 / EN
6.5 Cleaning the fuzz collector
1. Push to take the filter out.
2.Make the edge a litter deformed, then take the
filter net out.
3. After cleaning assemble the filter on right position.