Filter
Top Products
Washing Machine /User’s Manual
39 / EN
Troubleshooting
There is detergent left on the laundry. (**)
• Excessive laundry was loaded in. >>> Do not load the machine in excess.
• Wrong programme and temperature were selected. >>> Select the proper programme and temperature for the
laundry to be washed.
• Wrong detergent was used. >>> Select the proper detergent for the laundry to be washed.
Too much foam forms in the machine. (**)
• Improper detergents for the washing machine are being used. >>> Use detergents appropriate for the washing
machine.
• Excessive amount of detergent is used. >>> Use only sufficient amount of detergent.
• Detergent was stored under improper conditions. >>> Store detergent in a closed and dry location. Do not store in
excessively hot places.
• Some meshed laundry such as tulle may foam too much because of their texture. >>> Use smaller amounts of
detergent for this type of item.
• Detergent is put in the wrong compartment. >>> Put the detergent in the correct compartment.
• Softener is being taken early. >>> There may be problem in the valves or in the detergent dispenser. Call the
Authorized Service Agent.
Foam is overflowing from the detergent drawer.
• Too much detergent is used. >>> Mix 1 tablespoonful softener and ½ l water and pour into the main wash
compartment of the detergent drawer.
• Put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme and
consumption table”. When you use additional chemicals (stain removers, bleaches and etc), reduce the amount of
detergent.
Laundry remains wet at the end of the programme. (*)
• Excessive foam might have occurred and automatic foam absorption system might have been activated due to too
much detergent usage. >>> Use recommended amount of detergent.
* Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any
damage to the machine and to its surrounding environment. Laundry should be rearranged and re-spun.
** Regular drum cleaning might not be applied.>>> Clean the drum regularly. See, 6.2
A
WARNING: If you cannot eliminate the problem although you follow the instructions in this section,
consult the dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.