Filter
Top Products
32 / EN
Washing Machine /User’s Manual
Maintenance and cleaning
2. Open the filter cap.
If the filter cap is composed of two pieces,
press the tab on the filter cap downwards and
pull the piece out towards yourself.
If the filter cap is one piece, pull the cap from both
sides at the top to open.
C
You can remove the filter cover by slightly
pushing downwards with a thin plastic
tipped tool, through the gap above the
filter cover. Do not use metal tipped tools
to remove the cover.
3. Some of our products have emergency draining
hose and some does not have. Follow the steps
below to discharge the water.
Discharging the water when the product has an
emergency draining hose:
a. Pull the emergency draining hose out from its
seat
b. Place a large container at the end of the hose.
Drain the water into the container by pulling
out the plug at the end of the hose. When the
container is full, block the inlet of the hose
by replacing the plug. After the container is
emptied, repeat the above procedure to drain
the water in the machine completely.
c. When draining of water is finished, close the
end by the plug again and fix the hose in its
place.
d. Turn the pump filter to take it out.
Discharging the water when the product does not
have an emergency draining hose:
a. Place a large container in front of the filter to
catch water from the filter.
b. Loosen pump filter (anticlockwise) until water
starts to flow. Fill the flowing water into the
container you have placed in front of the filter.
Always keep a piece of cloth handy to absorb
any spilled water.
c. When the water inside the machine is finished,
take out the filter completely by turning it.
4. Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
5. Install the filter.
6. If the filter cap is composed of two pieces, close
the filter cap by pressing on the tab. If it is one
piece, seat the tabs in the lower part into their
places first, and then press the upper part to
close.