Beko WMI 61241 Washer User Manual


  Open as PDF
of 48
 
EN
10
Adjusting the feet
C
Do not use any tools to loosen the
locknuts.Otherwise,theycanbe
damaged.
1. Manually(byhand)loosenthelock
nuts on the feet.
2. Adjust them until the machine stands
level and firm.
3. Important:Tightenalllocknutsup
again.
Connecting to the water supply.
Important:
• Thewatersupplypressurerequired
to run the machine must be 1-10
bar(0,1–1MPa).(Practically,itis
necessarytohave10–80litersof
water flowing from the tap in one
minute to have your machine run
smoothly.)Attachapressure-reducing
valve if the water pressure is higher.
• Connectthespecialhosesupplied
with the machine to the water intake
valves on the machine.
• Inordertopreventwaterleakagethat
may occur at the connection points,
therearerubberseals(4sealsforthe
models with double water inlet and 2
sealsforothermodels)attachedtothe
hoses. These seals should be used
at the tap and machine connection
ends of the hoses. The plain end of
the hose fitted with a filter must be
attached to the tap and the elbowed
end must be attached to the machine.
Tighten the nuts of the hose well by
hand;neverusewrenchestotighten
the nuts.
• Openthetapscompletelyafter
making the hose connection to check
if there is any water leakage at the
connection points. Turn off the tap
and remove the nut in case of any
leakage. Retighten the nut carefully
after checking the seal. To prevent any
water leakage and any other damage
to be caused by it, keep the taps
closed when the machine is not in
use.
• Modelswithasinglewaterinletshould
not be connected to the hot water
tap. Laundry may be damaged or the
appliance may switch to protection
mode and not work.
When returning the appliance to its place
after maintenance or cleaning, care should
be taken not to fold, squeeze or block the
hoses.
Connecting to the drain
The water discharge hose can be
attached to the edge of a washbasin
or waste water system. The drain hose
should be firmly fitted into the drain as to
not loosen in its housing.
Important:
• Theendofthedrainhosecanbe
directly connected to the wastewater
drain or to the washbasin. The
fitting must be secured in all types
 previous next