Filter
Top Products
45 / EN
Washing Machine / User’s Manual
Problem Reason Solution
Detergent residue in the
detergent drawer. (**)
Detergent is put in wet drawer. Dry the detergent drawer before putting
in detergent.
Detergent has gotten damp. Keep detergents closed in an environment
free of humidity and do not expose them
to excessive temperatures.
Water pressure is low. Check the water pressure.
The detergent in the main wash compartment
got wet while taking in the prewash water.
Holes of the detergent compartment are
blocked.
Check the holes and clean if they are
clogged.
There is a problem with the detergent drawer
valves.
Call the Authorized Service Agent.
Detergent might be mixed with the softener. Do not mix the softener with detergent.
Wash and clean the dispenser with hot
water.
Regular drum cleaning is not applied. Clean the drum regularly. For this, please
see 4.7.2.
Too much foam forms in
the machine. (**)
Improper detergents for the washing machine
are being used.
Use detergents appropriate for the
washing machine.
Excessive amount of detergent is used. Use only sufficient amount of detergent.
Detergent was stored under improper
conditions.
Store detergent in a closed and dry
location. Do not store in excessively hot
places.
Some meshed laundry such as tulle may foam
too much because of their texture.
Use smaller amounts of detergent for this
type of item.
Detergent is put in the wrong compartment. Put the detergent in the correct
compartment.
Softener is being taken early. There may be problem in the valves
or in the detergent dispenser. Call the
Authorized Service Agent.
Foam is overflowing from
the detergent drawer.
Too much detergent is used. Mix 1 tablespoonful softener and ½
l water and pour into the main wash
compartment of the detergent drawer.
Put detergent into the machine suitable
for the programmes and maximum
loads indicated in the “Programme and
consumption table”. When you use
additional chemicals (stain removers,
bleachs and etc), reduce the amount of
detergent.
Laundry remains
wet at the end of the
programme. (*)
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent
usage.
Use recommended amount of detergent.
(*) Machine does not switch to spinning step when the laundry is not evenly distributed in the drum
to prevent any damage to the machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
(**) Regular drum cleaning is not applied. Clean the drum regularly. See 4.7.2
A
CAUTION: If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.