Beko WM 5140 S Washer User Manual


  Open as PDF
of 36
 
EN
22
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1. Pressthe“On/Off”button.
2. Select the programme and the
temperature.
3. Ifrequired(accordingtoyour
machine’smodel):
– selectanyauxiliaryfunction,
– adjustthespinspeed,
– setthetimedelay,
4. Close the loading door.
5. Press“Start/Pause/Cancel”button.
Canceling a program
• Press“Start/Pause/Cancel”button
for 3 seconds. At the end of this
time,“Start/Pause/Cancel”light
andalllightsgooffand“Spin”lamp
illuminates. If the door is unlocked,
all lights on the indicator will go off
andthe“Ready”lampwilllight.You
can select and start a new program
when“Ready”lightilluminates.
• Themachinecandrainallthewater
or can take in water for 3 times at
most to cool down the clothes and
complete the draining process. Also
the“Spin”lightilluminatesifthe
cancellation process is activated
in the middle of the program.
The“Spin”lightgoesoffwhen
discharging process is completed.
The door can be opened and a new
program can be selected when the
“Ready”lampilluminates.
Adding more laundry
• Thisisonlypossibleunderthe
followingconditions:
– duringtimedelay,
C
Youmayaddorremovelaundry
duringthetimedelay(untilthe
programstarts).
– Atthebeginningofawashingcycle,
C
Machineallowsaddingmorelaundry
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
oftheprogram:
1. Press“Start/Pause/Cancel”button.
Wait until the door is allowed to
open.Whenthe“Ready”lampison
continuously, continue to the next
step.
2. Opentheloadingdoorandputin
more laundry.
3. Close the loading door.
4. Press“Start/Pause/Cancel”button.
Program is in rinse hold mode
C
Clothes may be left to soak in the
machine as long as desired after
filling during the last rinse step.
When it reaches this position while
the machine is running, the “Start/
Pause/Cancel”lightwillflash.
If you wish to spin when the machine is
inthismode:
Press“Start/Pause/Cancel”button.
Programresumes.Yourmachinedrains
the water and spins your laundry.
If you want to discharge the water
withoutspinning:
• Press“Start/Pause/Cancel”button.
The program continues and only
drains the water.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
Ifyouwanttore-spintheclothes:
1. Rearrange the previously placed
clothes in machine.
2. Select the spin program.
3. Set the spin speed if spin speed
adjustment is available on your
machine.
4. Press“Start/Pause/Cancel”button.
6 Quick instructions for daily use
 previous next