Filter
Top Products
9
EN
the User Manual bag into the holes on
the rear panel. (P)
a safe place to reuse when the washing
machine needs to be moved again in
the future.
Never move the product without the
transportation safety bolts properly
fixed in place!
Connecting water supply
The water supply pressure required
from the fully open tap in one minute
to have your machine run smoothly.
water pressure is higher.
Models with a single water inlet should
not be connected to the hot water
tap. In such a case the laundry will get
damaged or the product will switch to
protection mode and will not operate.
Do not use old or used water inlet
hoses on the new product. It may
cause stains on your laundry.
with the product to the water inlet
2. Tighten all hose nuts by hand. Never
use a wrench when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for
water leaks at the connection points.
If any leaks occur, turn off the tap and
carefully after checking the seal. To
prevent water leakages and damages
caused by them, keep the taps closed
when the machine is not in use.
Connecting to the drain
directly connected to the wastewater
drain or to the washbasin.
Your house will be flooded if the
hose comes out of its housing during
water discharge. Moreover, there is
risk of scalding due to high washing
temperatures! To prevent such
situations and to ensure smooth water
intake and discharge of the machine,
fix the end of the discharge hose tightly
so that it cannot come out.
most.