Filter
Top Products
22
EN
Auxiliary function selection
Select the desired auxiliary functions before
starting the programme. Furthermore, you
can also select or cancel auxiliary functions
that are suitable to the running programme
without pressing the Start / Pause / Cancel
button when the machine is operating. For
this, the machine must be in a step before
the auxiliary function you are going to
select or cancel.
If the auxiliary function cannot be selected
or cancelled, light of the relevant auxiliary
function will blink 3 times to warn the user.
Some functions cannot be selected
together. If a second auxiliary function
conflicting with the first one is selected
before starting the machine, the
function selected first will be canceled
and the second auxiliary function
selection will remain active.
compatible with the programme cannot
be selected. (See "Programme and
consumption table")
according to the model of the machine.
soiled laundry. Not using the Prewash will
save energy, water, detergent and time.
excessive foaming, wash the nets/tulle
by putting little amount of detergent
into the main wash compartment.
Do not put detergent in the prewash
compartment.
This function enables the machine to
make another rinsing in addition to the one
already made after the main wash. Thus,
the risk for sensitive skins (babies, allergic
skins, etc.) to be effected by the minimal
detergent remnants on the laundry can be
reduced.
If you are not going to unload your
clothes immediately after the programme
completes, you can use rinse hold function
to keep your laundry in the final rinsing
water in order to prevent them from getting
wrinkled when there is no water in the
machine.
In models equipped with Spin Speed
and press Start / Pause / Cancel button if
you want to spin the laundry held in water.
In models not equipped with Spin Speed
Adjustment button, select Spin+Drain
programme if you want to spin your laundry
held in water.
In these models, you need to stop the
machine by pressing Start / Pause /
Cancel button before switching to spin
step and after drain step is completed
and the water in the machine is
drained. Thus, water inside the
machine is drained and your laundry is
not spun.
Use this function if you want to wash your
laundry in cold water.
Use this function if you do not want
your clothes be spun at the end of the
programme.
This function allows spinning of laundry at a
speed lower than the maximum spin speed
of the machine.
spin speed will be limited to the minimum
speed specified on the control panel.
Starting the programme
start the programme.
2. Start / Pause / Cancel button lights up
to indicate that the programme has
started.
3. Loading door is locked and Loading
Door light turns off.
Child Lock
Use Child Lock function to prevent children
from tampering with the machine. Thus
you can avoid any changes in a running
programme.
You can switch on and off the machine
with On / Off button when the Child
Lock is active. When you switch on the
machine again, programme will resume
from where it has stopped with the
child lock enabled.
To activate the Child Lock:
st
and 2
nd
Function buttons for 3 seconds