Washing Machine /User’s Manual
13 / EN
Installation
100cm
40cm
•Topreventflowingofdirtywaterbackintothe
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do
not drive it in the drain more than 15 cm. If it is
too long, cut it short.
•Theendofthehoseshouldnotbebent,it
should not be stepped on and the hose must
not be pinched between the drain and the
machine.
•Ifthelengthofthehoseistooshort,useitby
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.
3.6 Adjusting the feet
A
WARNING: In order to ensure that the
product operates more silently and vibration-
free, it must stand level and balanced on its
feet. Balance the machine by adjusting the
feet. Otherwise, the product may move from
its place and cause crushing and vibration
problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level
and balanced.
3. Tighten all lock nuts again by hand.
A
WARNING: Do not use any tools to loosen
the lock nuts. Otherwise, they will get
damaged.
3.7 Electrical connection
Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall not
be liable for any damages that will arise when the
product is used without grounding in accordance
with the local regulations.
•Connectionmustcomplywithnational
regulations.
•Powercableplugmustbewithineasyreach
after installation.
•Ifthecurrentvalueofthefuseorbreakerinthe
house is less than 13 Amps, have a qualified
electrician install a 13 Amp fuse.
•Thevoltagespecifiedinthe"Technical
specifications" section must be equal to your
mains voltage.
•Donotmakeconnectionsviaextensioncables
or multi-plugs.
B
WARNING: Damaged power cables must
be replaced by the Authorised Service
Agents.