Filter
Top Products
17
EN
Auxiliary function
Low temperature
This function allows for drying at lower
temperatures and therefore saves energy.
Warning LED will light up when you select
the function.
C You must use this function when you
dry your synthetic or delicate laundry.
Warning indicators
C
Warning indicators may differ
according to the model of your
machine.
Filter cleaning
A warning LED will light up to remind lter
cleaning after the programme nishes.
C If the filter cleaning warning LED
lights up continuously, please refer to,
“Solution suggestions for problems”.
Starting the Programme
1. Press “Start/Pause/Cancel” button to
start the programme.
2. “Start/Pause/Cancel” button will light
up to indicate that the programme has
started.
Timer follow-up indicator
One of the LED lights will remain on as
far as programme runs and shows the
approximate remaining time.
CLEDs on the timer follow-up indicator
will also flash when the child-proof lock
is activated.
Changing the programme after
the programme has started
You can use this feature to dry your
laundry in a different programme after
your machine has started to run.
For example;
Press and hold the “Start/Pause/Cancel”
button for about 3 seconds to select
“80” minutes programme instead of “60”
minutes programme
Select the “80” minutes programme by
rotating the programme knob.
Press “Start/Pause/Cancel” button to
start the programme.
C The programme which is selected
first will go on even if the programme
selection button is moved and another
programme mode is selected while the
machine is operating. You must cancel
the ongoing programme in order
to change the drying programme.
(See, Ending the program through
cancelling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after
the start-up of the programme
1. Press the “Start/Pause/Cancel” button
to switch the machine to “Pause”
mode. Drying process will stop.
2. Open the door at Pause position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to
start the programme.
C Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet clothes and the
result will be wet laundry after the
drying process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but as this process will
interrupt drying continuously, it will
extend the programme
duration and increase energy
consumption. Therefore, it is
recommended to add laundry before
the drying programme is started.
Child-proof lock
There is a childproof lock to prevent any
programme interruption due to the
pressing of keys while the programme
is on. The loading door and all keys
except the “On/Off” key on the panel
are deactivated when the child-proof
lock is active.
In order to activate the childproof lock,
press the “Start/Pause/Cancel” and “Low
temperature” buttons simultaneously for 3
seconds.To start a new programme after
the programme is over or to interrupt the
programme, the childproof lock should be
deactivated. To deactivate the childproof
lock, press the same buttons for 3 sec.