Beko DC 7110 Clothes Dryer User Manual


 
3
EN
1 Important safety information
This section includes safety information that will
help protection from risks of personal injuries
or materialistic damages. Failure to follow
these instructions shall cause any warranty and
reliability commitment to become void.
General safety
Never place the machine on a carpet-covered
floor, otherwise, lack of airflow beneath
the machine may cause electrical parts to
overheat. This will cause problems with your
machine.
If the power cable or mains plug is damaged,
you must call Authorised Service Agent for
repair.
The product should not be plugged in during
installation, maintenance and repair works.
Such works should always be made by the
technical service. Manufacturer shall not
be held responsible for damages arising
from processes carried out by unauthorised
persons.
Connect the product to a grounded outlet
protected by a fuse of suitable capacity as
stated in the technical specifications table.
Operate your product at temperatures
between +5°C and +35°C.
Do not use electrical devices in the product.
Do not connect the air exit of the product
to the chimney holes which are used for the
exhaust fumes of the devices operating with
gas or other types of fuel.
You must provide enough ventilation in
order to prevent gases exiting from devices
operating with other types of fuels including
the naked flame from accumulating in the
room due to the back fire effect.
Always clean the lint filter before or after each
loading.
Never operate your dryer without the lint filter
installed.
Do not allow fibre, dust and dirt accumulation
around the exhaust exit and at adjacent
areas.
Power cable plug must be within easy reach
after installation.
Do not use extension cords, multi-plugs
or adaptors to connect the dryer to power
supply in order to decrease the risk of electric
shock.
Do not make any changes on the plug
supplied with the product. If it is not
compatible with the socket, have a qualified
electrician change the socket with a suitable
one.
Items cleaned or washed with gasoil/fuel oil,
dry-laundry solvents and other combustible
or explosive materials as well as the items
that are contaminated or spotted with such
materials should not be dried in the product
since they emit flammable or explosive vapor.
Do not dry items cleaned with industrial
chemicals in the dryer.
Do not dry unwashed items in the dryer.
Items soiled with cooking oils, acetone,
alcohol, fuel oil, kerosene, stain remover,
turpentine, paraffin and paraffin removers
must be washed in hot water with plenty of
detergent before being dried in the dryer.
Garments or pillows bolstered with rubber
foam (latex foam), shower bonnets, water
resistant textiles, materials with rubber
reinforcement and rubber foam pads should
not be dried in the dryer.
Do not use fabric softeners and anti-static
products unless they are recommended by
the manufacturers of the fabric softener or
the product.
This product must be grounded. Grounding
installation decreases the risk of electric
shock by opening a path with low resistance
for the electricity flow in case of a malfunction
or failure. Power cable of this product is
equipped with a conductor and a grounding
plug that allows for grounding the product.
This plug must be installed appropriately and
inserted into a socket which is grounded
in accordance with the local laws and
regulations.
Do not install the product behind a door with
a lock, sliding door or a door that has a hinge
against the hinge of the dryer.
Do not install or leave this product in
places where it will be exposed to outdoor
conditions.
Do not tamper with the controls.
Do not perform any repair or part replacing
procedures on the product even if you know
or have the ability to perform unless it is
clearly suggested in the operating instructions
or the published service manual.
Inside and exhaust duct of the product must
be cleaned by the qualified service personnel
periodically.
Wrong connection of grounding conductor
of the product can cause electric shock. If
you have any suspect about the grounding
connection, have it checked by a qualified
electrician, service representative or service
personnel.
Do not reach into the machine when the
drum is spinning.
Unplug the machine when it is not in use.
Never wash down the appliance with water!
There is the risk of electric shock! Always