Filter
Top Products
15
EN
5 Maintenance and cleaning
Filter Cartridge / Door Inner Surface
Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
“Filter Cartridge”.
C Such fibre and lint are generally formed
during wearing and washing.
C Always clean the filter and the inner surfaces
of the cover after each drying process.
C You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by hand
or with a soft piece of cloth.
4. Close the filter and place it back into its
seat.
C Clogging may arise on the filter surface after
using your machine for some time; if this
occurs, wash the filter with water and dry it
before using again.
C Clean the entire inner surface of the cover
and door gasket.
Water tank;
The moisture in the damp laundry is taken from
the laundry and condens ed. Drain the water
tank after each drying cycle or during drying
when “Water tank” warning light turns on.
ACondensed water is not drinkable!
ANever take out the water tank when the
programme is running!
If you forget to drain the water tank, your dryer
will stop during the following drying cycles
when the water tank is full and the “Water
tank” warning light will turn on. If this is the
case, press the “Start/Pause/Cancel” button to
resume the drying cycle after draining the water
tank.
*To drain the water tank:
1-Carefully remove the water tank by opening
the kick plate cover/pulling the drawer.
2-Drain the water in the tank
3-If there is lint accumulation in the funnel of the
water tank, clean it under running water.
4-Place the water tank into its seat.
For the condenser;
Hot and humid air in the condenser is cooled
with the cold air from the room. Thus, the humid
air circulating in your dryer is condensed and
then pumped into the tank.
C Clean the condenser after every 30 drying
cycles or once a month.
To clean the condenser:
1. If a drying process has been carried out, open
the door of the machine and wait until it cools
down.