Filter
Top Products
Water intake filter
At the end of the water intake connection module and water inlet
hose-tap side, there exists filters. These filters prevent any dirt and
objects passing into the machine. It is advisable that these filters
should be cleaned every 30-40 washes. To clean the filter, first turn
the tap off. Then, disconnect the hose and clean the filter with a
thin brush. If the filter is very dirty, you may clean it by pulling out
with pliers. To clean the filter at the tap side of the hose, pull it out
by hand and clean the filter under the tap water.
Hose
To prevent any leakage, have a technician to control the hoses
every two years. If the machine is placed at cold ambient
temperatures, the water remining inside the pump and hoses should
be removed from the filters. Also to prevent freezing, empty the
water intake hoses by disconnecting from taps.
Drum
Do not leave any metal objects (pins, needles, etc.) inside the
drum. These objects may cause rust on the drum surface. Do not
clean the drum with scratching elements.
15
Detergent dispensing drawer
Clean when necessary:
1. Open the drawer as far as possible.
2. Push down the depression on the suction cup and pull the drawer
out completely.
3. Clean the drawer under warm running water. Pull off the suction
cup; Clean
suction cup and opening in the drawer with warm running water,
pierce the opening with a needle if necessary. Replace the suction
cap.
4. Wipe off detergent residue from the drawer guides. If present,
remove calc deposits from the water-jet nozzles (inside the drawer).
Foreign matter trap
• Clean the foreign matter trap at least once after every 30 wash
cycles!
• Clean foreign object trap, if foreign objects (coins, buttons, baby
socks,
etc.) are blocking the suds pump.
• Drain left-over water before cleaning (see below).
5
Care and maintanence