Filter
Top Products
Page 18
THE PRESET PROGRAMS
ASKO dryers are delivered with the four most commonly used programs. The table below lists the preset programs
and the settings for each. To select a program, simply press one of the program buttons and press Start. For
additional programming options, refer to “Customizing the Preset Program Buttons” below.
With ASKO’s Sensidry™ system, you need never worry about over-drying your laundry. Just select the proper program
for the type of fabric you’re drying and Sensidry does the rest. Once you select a program, Sensidry monitors the
temperature and measures the humidity level. When it detects the appropriate measurements, it automatically shuts
off the machine.
(1) The Quick cooling time is 5 minutes.
(2) On Model T781, the dry temperature for program P4 is Normal.
NOTES:
WARNING!
Some fabrics may not be able to withstand extremely hot temperatures. Always refer to the
garment care label to recommended wash temperatures.
Preset Dry Cooling Anti-
Program Dry Cycle Temp Time Buzzer Crease
P1 Extra Dry Normal Quick
(1)
On 1 hr.
P2 Dry Normal Quick On 1 hr.
P3 Normal Dry Normal Quick On 1 hr.
P4 Iron Dry Low
(2)
Quick On 1 hr.
CUSTOMIZING THE PRESET PROGRAM BUTTONS
Options Definitions
Cool-down This option tumbles the clothes without heat for a few minutes after the program ends to
reduce wrinkling. The Normal cool-down tumbles for 15 minutes; the Quick for 5 minutes.
Buzzer If this option is on, a buzzer sounds for 3 seconds at the end of the program.
Anti-crease This option is designed to prevent wrinkling if you’re unable to remove them from the dryer
right away. After the program ends, the drum will continue to rotate for three seconds every
minute until the door is opened or one hour has passed. You can turn this option off or
choose 1, 2, or 3 hours.
Temperature You have three temperature options: Normal, Low, and Air Fluff. Normal is for heavier fabrics,
such as denim, cotton, and linen. Low is for lighter, more delicate fabrics, such as synthetics.
Air Fluff does not activate the heating element. It simply circulates the air as it tumbles to
shake out the dust and refresh the clothes.
Delayed Start You can set a delayed start from 1 to 24 hours. This option is useful in areas where utility
companies offer discount rates for off-peak hours.
Timed Dry You can set the program length, from 5 to 90 minutes.
In addition to the preset programs listed above, you can customize the preset buttons to use any of the programs listed
in the table below. This table also lists the pre-programmed settings for each program. For example, if you select
Normal dry on the program menu, it is automatically programmed to dry at the low temperature, cool-down for 15
minutes (normal time), run the anti-crease cycle for one hour, and set off the buzzer when the program ends. You can
modify some of these settings. (See “Dry Program Options” below.)
PROGRAM OPTIONS
The table below defines the program options. The next table lists all of the programs on the Program menu as well as
the settings and options available with each.
Program Dry Temp Cooling Time Anti-Crease Buzzer
Extra dry Normal 15 minutes 1 hour On
Dry Normal 15 minutes 1 hour On
Normal Dry Low 15 minutes 1 hour On
Iron Dry Low 15 minutes 1 hour On
Air fluff n/a n/a 1 hour On
Timed dry Low 15 minutes 1 hour On
AVAILABLE PROGRAMS
OPTION DEFINITIONS