Filter
Top Products
Page 16
T731 ERROR MESSAGES
Error messages will display on the LED if a fault occurs
while a program is in progress. The table below defines
each possible error message. If the message still
displays after you have checked the possible solutions,
call a service technician.
MESSAGE ERROR
F1 Call a service technician.
F2 There may have been a power outage. Check the breaker box and fuses.
The dryer is programmed to stop after a maximum of 3 hours drying time. If it has run this long,
let it cool and try to start the program again.
Try turning the power off then on again. If the message remains, call a service technician.
F3 This indicates a thermistor fault. Call a service technician.
F4 This indicates the overheat protection device has activated. Clean the lint filter and try running
the program again.
F5 This indicates a fault in the moisture sensor. Running a dry program with dry clothes or an
empty machine could also cause this error. Try opening the door. If the message remains, call a
service technician.
BUZZER
Press this button to set a buzzer to sound for three
seconds when a program is complete. The indicator
light will stay lit when this option is on.
If you selected the Anti-crease option, the buzzer will
sound every time the drum rotates.
COOL-DOWN
Every program, except Air Fluff, ends with a cool-down
cycle that tumbles the clothes without heat to reduce
wrinkling. The Cool-down button lets you choose
between the Normal cool-down cycle (15 minutes) or a
Quick cool-down cycle (5 minutes). The indicator light
will stay lit when Quick is selected.
CHANGING OPTION SETTINGS
You cannot change the option settings after you have
pressed Start. To change a setting, hold down the Stop
button until the unit stops, make your change, then press
Start again. The program will restart from the beginning.
PROGRAM MEMORY
The dryer is designed to retain the settings last selected
with each program. For example, if you select Normal
Dry, the Low temperature option, a 2-hour anti-crease,
and Quick cool-down, next time you select Normal Dry
these options will automatically be selected.
CHILD-SAFE START FEATURE
You can program the dryer not to start unless the Start
button is held down for three seconds. This is to prevent
children from inadvertently starting the machine. To
program this function, follow the steps below:
1. Turn the machine off then on again. (“00” should show
on the LED.)
2. Press the Start button five times in succession then
press the Anti-Crease button five times. (This must
be done within 15 seconds.)
3. Within three seconds, press the Anti-crease button
again to select Child-safe start. The LED will display
“3” to indicate the Child-safe start is active. (If the
child-safe start has already been activated, “0” will
display after you press the Anti-crease button.)