Filter
Top Products
33
2) Selection (setting) changes can be made at any time during the drying cycle by opening and closing
the main door and then making a new selection.
3) Additional time can be purchased at any time. If the dryer is in operation (drying mode) and additional
coins are inserted, the LED display will read the additional time for amount inserted.
2. Non-Coin (OPL) Dryers
The dryer is available for use when the LED display reads “FILL”. Once the load has been put into the dryer and
the main door is closed, start the dryer as follows:
a. Determine fabric setting (selection). Setting “HIGH TEMP” is the high-temperature range, the “PERM
PRESS” is the medium-temperature range, and the “LOW TEMP” setting is the low-temperature range.
b. Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the
fabric setting key desired.
c. The dryer will now start, and the LED display for the basket (tumbler) selected will read the setting
(selection) and the drying portion of the LED display will read “00” and count upwards in time.
d. Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will sound
for five (5) seconds, and the LED display will read “donE”.
NOTE: If the Anti-Wrinkle program is active, the LED display will remain reading “donE”, and the
Microprocessor Controller (computer) will proceed through the Anti-Wrinkle program until the
maximum “Active Guard Time” has expired or until the main door is opened, whichever comes
first.
NOTE: If the Anti-Wrinkle program is not active or in use, the LED display will read “donE” until the
main door is opened, at which time, the LED display will read “FILL”.
e. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer, shut
the main door and press desired setting.
NOTE: When a cycle is interrupted by opening the main door, cycle time will continue to count upward,
regardless if the door is open or closed until a keyboard (touchpad) selection is made.
2) Selection (setting) changes can be made at any time during the drying cycle by opening and closing the
main door then making a new selection.