Filter
Top Products
113203-3 Maytag 29
SECTION IV
OPERATING INSTRUCTIONS
A. COIN MODE
1. When at least one (1) of the dryer’s pockets is in the ready state and no cycle is in progress, the liquid
crystal display (L.C.D.) screen will display a ready prompt depending on the READY PROMPT option in
PL01 Control Settings. If the option is set to “READY, INSERT AMOUNT TO START”, the display will
read “READY, INSERT $ XX.XX TO START”. If the READY PROMPT option in PL01 is set to
“READY”, the display will read “READY.” If both pockets are idle, both sections of the L.C.D. will
display the selected READY PROMPT message.
2. Insert coin(s). Once the correct “Amount to Start” has been inserted, the pocket will now display “SELECT
TEMP TO START”. If the other pocket was already in a cycle, that pocket will display “SELECT TEMP
TO ADD TIME”. If both pockets were idle, both pockets will display “SELECT TEMP TO START”.
3. Select temperature by pressing “HIGH,” “MEDIUM,” or “LOW” on the dryer pocket you wish to start the
cycle in. The cycle will start and the L.C.D. will display the Dry Cycle selected and the remaining time.
4. The dryer will continue through the drying and cooling cycles until the vended time has expired.
5. Upon completion of drying and cooling cycles the buzzer will sound, and the dryer will go into Wrinkle
Guard mode for 99 minutes or until the door has been opened.
6. HOT KEYS – When the control is in coin mode, the HOT KEYS are disabled. The HOT KEYS can be
enabled only if the dryer is in a dry cycle. The HOT KEYS cannot be enabled if the dryer is in “READY,
INSERT 25¢ TO START” mode. To enable the HOT KEYS when the controller is in a dry cycle, toggle
the program switch to the “UP” position. Once the program switch is in the “UP” position, the HOT
KEYS are enabled. The HOT KEYS are as follows:
Pressing and holding the “HI” key will show the remaining credit available.
Pressing and holding the “MED” key will show the temperature readings of the exhaust probe. The
exhaust probe temperature reading is displayed on the left. If the dryer is an axial model, the temperature
reading of the axial temperature transducer will also be displayed; this will be the middle temperature
reading.
Pressing and holding the “LO” key will show the RPMs of the basket (tumbler).
The “PAUSE” key will pause the dryer. If the dryer is paused, pressing the “HI” , “MED” , or
“LO” key will restart the dryer into the appropriate drying cycle. Once the dry cycle has started again,
the HOT KEYS will be enabled again.