Filter
Top Products
11
1. Leveling Dryer
a. To level the dryer, place 4-inch metal shims or other suitable material under the base pads. It is suggested
that the dryer be tilted slightly to the rear (refer to the illustration above).
b. The V-belts are disconnected from the tumbler drive motor for shipping. Reconnect V-belts before
starting the dryer.
B. UNPACKING/SETTING UP
Remove protective shipping material (i.e., plastic wrap, and/or optional shipping box) from dryer.
IMPORTANT: Dryer must be transported and handled in an upright position at all times.
The dryer can be moved to its final location while still attached to the skid or with the skid
removed. To un-skid the dryer, locate and remove the four (4) lag bolts securing the base of the dryer to the
wooden skid. Two (2) are at the rear base, and two (2) are located in the bottom of the lint chamber. To remove
the two (2) lag bolts located in the lint chamber area, remove the lint drawer and the three (3) Phillips head
screws securing the lint door in place.