Filter
Top Products
37
IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count the time, either upward or
downward, depending on which parameter is programmed. Continuation of the cycle
will resume only after the door has been closed and any other of the three (3)
temperature selection buttons is again depressed.
c. Once the preprogrammed dryness level and cool down period has been reached or the maximum
automatic time has expired, whichever comes first, the tone (buzzer) will sound for 5-seconds, and the
light emitting diode (L.E.D.) display will read “donE,” at which time the dryer will shut off.
NOTES: 1. If the Anti-Wrinkle program is active, the L.E.D. display will continue to read “donE,” and
the microprocessor controller (computer) will proceed through the Anti-Wrinkle program
until the maximum “Active Guard Time” has expired or until the door is opened, whichever
comes first. The L.E.D. display will read “FILL” and/or “Amount To Start.”
2. If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read “FILL”
and/or “FrEE.”
4. Non-Microprocessor Controller (Computer) Models
a. Turn power on to the dryer.
b. Insert coins, rotary meter type only.
c. Select temperature by using rocker switch and selecting “HI TEMP,” “LO TEMP,” or “PERM PRESS.”
d. Press “Push To Start” button to start the cycle.
e. Upon completion of the drying and cooling cycles the dryer will shut off.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. Continuation of the
cycle will resume only after the door has been closed, and the “Push To Start” button is
pressed.
OPL MODELS
1. To start the dryer:
a. Microprocessor Controller (Computer) Dryers...
1) Light emitting diode (L.E.D.) display will read “REAdY” (meaning no cycle in progress).
2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key “E”)...
a) The dryer will then start (rotate).
3) L.E.D. display will now show “Cycle In Progress” and “Cycle Status” meaning that the dryer is in
the drying cycle (dry mode for 30 minutes) and count downwards in minutes.