Filter
Top Products
61
SECTION XI
BURNER AND BASKET (TUMBLER)/LINT CHAMBER
MANUAL RESET HI-LIMIT INSTRUCTIONS
I M P O R T A N T
MANUAL RESET HI-LIMIT INSTRUCTIONS
FOR TIMER OR PHASE 5 WITHOUT HEAT FAULT
(GAS MODELS ONLY)
This dryer was manufactured with a burner and basket (tumbler)/lint chamber* manual reset hi-limit thermostat.
If either the hi-limit thermostat is open prior to the start of the drying cycle, or during the cycle, the dryer will not
recognize the open state of the hi-limit thermostat and will start or continue through the drying cycle with no heat.
The applicable manual reset hi-limit thermostat must be reset manually.
This hi-temperature condition may be caused due to a restricted exhaust, poor airflow, or improper burner oven
operation.
The location of the burner manual reset hi-limit switch is on the right side of the burner box.
* Models manufactured as of November 7, 2001 have an automatic reset lint chamber hi-limit.
IMPORTANT
This dryer is equipped with a burner
hi-limit and tumbler/lint chamber* hi-limit
thermostat which must be reset manually.
WARNING: Discontinue power to dryer
before attempting to reset hi-limit.
ADC P/N:114093