Filter
Top Products
18
Reinstall the door
1. Reattach door to dryer front panel with the 4 screws.
A
B
A.Dryer front panel
B.Door assembly
2. Check for fingerprints on the glass. Clean glass if necessary.
Close door and check that it latches securely.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Di
spose of/recycle all packaging materials.
4. Check the dryer’s final location. Be sure the vent is not
crushed or kinked.
5. Check that the dryer is level. See “Level Dryer.”
6. For power supply cord installation, plug into an outlet. For
direct wire installation, reconnect power.
7. Remove the blue protective film on the console and any tape
remaining on the dryer.
8. R
ead “Dryer Use.”
9. Wipe
the dryer drum interior thoroughly with a damp cloth to
remove any dust.
10. Sel
ect a Timed Dry heated cycle, and start the dryer. Do not
select the Air Dry Temperature setting.
If the dryer will not start, check the following:
■ Controls are set in a running or “On” position.
■ The Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical supply
is connected.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
11. When
the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.
If you do not feel heat, tu
rn off the dryer and check the
following:
■ There may be 2 household fuses or circuit breakers for
the dryer. Check that both fuses are intact and tight, or
that both circuit breakers have not tripped. If there is still
no heat, contact a qualified technician.
NOTE:
You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used. The
odor will go away.