Filter
Top Products
13
3. Move the large hole screw to the opposite side. Remove the
2 plug screws and plastic plugs, and insert them in the
original scr
ew holes on the opposite side.
A.Hinge screws
B.Large hole screw
C.Plug screws and plastic plugs
A
C
B
4. Move hinge to the other side and reattach with the 4 screws
removed in Step 2. Make sure locator pins line up in holes
and drive the top 2 screws in place first to help drive locator
pins into proper location.
5. Set the inner door assembly aside.
Reverse the door handle
1. Place the outer door assembly face down on work space.
2. Re
move the 6 screws that hold the intermediate door to the
outer door assembly. Remove the intermediate door, and set
hinge shield aside. Remove the hinge hole cover.
A.Intermediate door
B.Hinge shield
C.Hinge hole cover
B
A
C
3. Rotate the window assembly 180º and reattach the
intermediate door, hinge shield, and hinge hole cover
with the 6 screws removed in Step 2.
Reinstalling the door
1. Place the inner door assembly into the outer door assembly.
To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge.
2. R
eassemble the inner and outer door assemblies with the
5 screws.
3. Remove existing label from the opposite side of the door and
discard. Find label provided with the Use and Care Guide and
apply over original hinge holes.
4. Align the door by placing the locating tabs on the hinge with
the locating holes on the dryer front panel. Insert and tighten
the center hinge screw. The door will hang in place while you
insert and tighten the remaining 4 screws.
NOTE: Two or more people may be needed to reattach the
dryer door.
B
C
A
A.Dryer door
B.Dryer front panel
C.Insert this hinge screw first.
5. Close the door and check that it latches securely.
6. Che
ck for fingerprints on the glass. Clean the glass if
necessary.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. C
heck that you have all of your tools.
3. Check
the dryer’s final location. Be sure the vent is not
crushed or kinked.