Filter
Top Products
19
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.amana.com/help
In Canada: www.amanacanada.ca
Washer displaying code message and tone sounds
“F20” (Water Inlet Problem—no water or insufcient
water supply)
Select STOP twice to cancel the cycle. Unplug washer or
disconnect power.
Check the following:
Are both hot and cold water faucets completely turned on?
Are screens at inlet hose connection to washer clogged?
Are water inlet hoses kinked?
Are water inlet hoses frozen?
Plug in washer or reconnect power. Re-select cycle and press
START. If the problem remains, call for service.
“F21” (Drain Problem)
Select STOP twice to cancel the cycle. Unplug washer or
disconnect power.
Check the following:
Is the drain hose kinked?
Is the drain hose frozen?
Is the drain hose clogged?
Is the drain hose more than 96" (2.4 m) above the oor?
Plug in washer or reconnect power. Re-select cycle and press
START. If the problem remains, call for service.
“SUD” (Suds Routine)
When excessive suds are detected, a suds routine
automatically starts. This routine removes extra suds and
assures proper rinsing of your garments. “SUD” is displayed
during rinsing and at the end of the cycle to inform you that
Suds Routine was activated. Use only HE (High Efciency)
detergents.
“F22” (Front door lock)
Select STOP twice to cancel the cycle.
Check the following:
Is the washer door rmly shut?
The door must be completely closed for the washer to
operate. The door may look closed, but may not be latched.
Open the door and close rmly.
Were you washing a large load?
Before you close the washer door, check for laundry items
sticking out beyond the door opening. Leave enough space
in the washer to allow the clothes to tumble freely. An
overloaded basket may keep the door from shutting
completely. Reduce your load size if needed.
Press POWER and select START.
“F” codes other than F20, F21 or F22
Select STOP twice to cancel the cycle. Select RINSE/DRAIN
& SPIN if there is excessive water in the washer.
Re-select cycle and press START. If the problem remains,
call for service.
Washer won’t start
Check the following:
Is the power cord plugged into a grounded 3 prong outlet?
Is the washer door rmly closed?
Has a cycle been selected, but START has not been selected
and held for 1 second?
Was the door open after completion of last cycle?
Washer won’t ll, wash, or rinse
Check the following:
Is the power cord plugged into a grounded 3 prong outlet?
Is there power at the plug? Check electrical source or call
an electrician.
Are the hot and cold water faucets turned on?
Is the water inlet hose kinked?
Are the water inlet valve screens clogged?
Turn off the water and remove inlet hoses from the washer.
Remove any accumulated lm or particles. Reinstall hoses,
turn water on and check for leaks.
Washer stops
Check the following:
Is the power cord plugged into a grounded 3 prong outlet?
Is there power at the plug?
Check electrical source or call an electrician.
Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Are you using an extension cord?
Do not use an extension cord.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
WARNING