Filter
Top Products
Programming
13
F232133
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5. Install or remove jumpers to achieve the desired
cycle time. Figure 3 through Figure 12 illustrate
the possible combinations.
NOTE: Do not remove the cover from the
mechanical timer. Removing this cover will void
the warranty.
No jumpers installed on the board
Removing all the jumpers from 1a extends the cycle
time, making it as long as possible. Refer to Figure 3.
NOTE: Do not remove the wire from the 1a
terminal on timer. Removing this wire disables the
timer. To extend cycle time, remove the wires after
the 1a terminal on timer.
Figure 3
1a to 3a
This jumper configuration shortens the wash step from
eight minutes to four minutes. Refer to Figure 4.
Figure 4
1a to 3a to 3b
This configuration eliminates the prewash step and
shortens the wash step from eight minutes to four
minutes. Refer to Figure 5.
Figure 5
1a to 3a to 3b to 5b
This configuration eliminates the prewash step,
shortens the wash step from eight minutes to four
minutes, and shortens the final spin time from four
minutes to two minutes. Refer to Figure 6.
Figure 6
1a to 3a to 5a
This is the factory-preset jumper configuration. This
configuration shortens the prewash step from four
minutes to two minutes and shortens the wash step
from eight minutes to four minutes. Refer to Figure 7.
Figure 7
1a to 3a to 5a to 5b
This configuration shortens the prewash step from four
minutes to two minutes, shortens the wash step from
eight minutes to four minutes, and shortens the final
spin time from four minutes to two minutes. Refer to
Figure 8.
Figure 8
1b 1 1a
3b 3 3a
5b 5 5a
1b 1 1a
3b 3 3a
5b 5 5a
1b 1 1a
3b 3 3a
5b 5 5a
1b 1 1a
3b 3 3a
5b 5 5a
1b 1 1a
3b 3 3a
5b 5 5a
1b 1 1a
3b 3 3a
5b 5 5a