Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
9
F232161
Test Cycle
Cycle number 01 is a test cycle to check out all
machine functions. The program for the cycle is shown
following the copy of the Program Worksheet.
The first step is a cold fill to low level and is designed
to give not quite enough time to complete a fill and
cause the display to read “FILL”. When the START
key is pressed again, it should continue to fill and
proceed with the test cycle.
The steps in the test cycle are relatively short with the
exception of step 3, step 15, and step 17. These can be
shortened by pressing the ADVANCE key to go on to
the next step.
End of Cycle
When the cycle is completed, the display will show
“NEXT” plus the cycle number just run. To unload the
machine, press the door unlock button and again open
the door to remove contents and place them in the
dryer.
To display temperature, press the DISPLAY TEMP.
key. Display will read “---F” as long as the key is
pressed and will update display automatically.
It is possible to skip to the next step in the cycle except
a drain step. To do so, press the ADVANCE key. Drain
procedures must be allowed to complete.
LED Display
When display shows letters and/or numbers with or
without the beeper, refer to Table 1. The computer
control in this machine is continuously on the alert for
problems both within the machine and with the total
installation. As the computer sees a problem, it
immediately flashes a letter or number or both on the
display and may activate the beeper as well. Table 1
shows the various displays and what they mean. The
operator should become familiar with these computer
displays.
NEVER insert hands or objects into
basket until it has completely stopped.
Doing so could result in serious injury.
SW012
WARNING