Filter
Top Products
Programming
F232141
12
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
14. Use Up or Down (arrow) key to select Drain
Option: “drAI” (drain) or “nodr” (no drain).
NOTE: The drain step in the final segment cannot
be skipped.
15. For VNV models only, select spin speed for
Fill 9: “SPn1” (Low), “SPn2” (Medium), or
“SPn3” (High).
16. Display will flash “SPIn” and “tInE”. Use Up or
Down (arrow) key to select spin time: 1 to
10 minutes (00 for no spin). Press Start (#) key.
The display will show the identifier for the next
program segment.
17. Press the Stop (*) key to complete the cycle
programming procedure.
Test Cycle
To select test cycle:
1. Flip program switch to up position (RUN Mode).
2. Press Down (arrow) key. Display will show
“tESt” and “CYC”.
3. Press Start (#) key to begin.
The ability to advance to the next cycle step is possible
by pressing the Start (#) key.
Refer to the following Cycle Charts section for
detailed description of cycles.