Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
800536
22
Step 4: Set Fabric Selector
Set regular loads at NORMAL or PERM PRESS. Set
delicate loads at DELICATE.
Figure 19
Step 5: Set WASH/RINSE Temperatures
Set at HOT (COLD rinse), WARM (COLD rinse) or
COLD (COLD rinse).
NOTE: Always follow manufacturer’s care labels.
Figure 20
Step 6: Insert Money
Place coin(s) in slide and carefully push in as far as
possible and then pull slide out as far as possible. After
IN USE light comes on (indicating start of cycle),
press the PUSH-TO-START button.
Figure 21
Indicator Lights
IN USE
This light will remain on while washer is in use.
DOOR LOCKED
This light will come on after the start button has been
pushed and the washer door has locked. It will remain
on until the wash cycle has ended.
FINAL SPIN AND TUMBLE
This light will come on at the start of the final spin and
remain on until the wash cycle has ended.
CLOSE DOOR
This light will come on if door is not closed tightly.
Firmly push door until light goes out.
IMPORTANT: If washer fails to operate properly
after installation, make sure electrical service and
water supply faucets are turned on. Are all the
controls properly set? Have a qualified service
person refer to the wiring diagram (located inside
of cabinet) and check for broken, loose or incorrect
wiring.
NOTE: Once a cycle has started, the door can only
be opened by first unplugging the power cord and
waiting one minute.
The washer will stop (pause) shortly before the first
spin and final spin.
H171I
H170I
W297I
H171I
H170I
To reduce the risk of bodily injury, do not
remove laundry from washer until all
lights are out, and all moving parts have
stopped.
W092
WARNING