Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
11
800536
Installing the Washer
Step 1: Position Washer Near Installation
Area
Move washer so that it is within four feet of the
desired area of installation.
Figure 2
Step 2: Connect Water Inlet Hoses
NOTE: Refer to section on Water Supply
Requirements before connecting water inlet hoses.
Remove the four plain rubber washers from accessories
bag, and install them according to Figure 3.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately
1/4 turn with pliers. DO NOT cross thread or
overtighten couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
Figure 3
Figure 4
H135I
H135I
H091I
1 Rubber Washer (Plain)
2 Inlet Hose
H137I
1 Water Supply Faucets
2 Hot Water Connection
3 Cold Water Connection
4 Water Inlet Hoses
2
1
1
H137I
2
1
3
4
WATER
MIXING
VALVE