Filter
Top Products
Maintenance
17
F232134
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
7. Use compressed air to clean lint from motor.
8. Clean interior of machine, both basket and shell,
by wiping with a water-soaked sponge or cloth.
9. Use compressed air to clean all electrical
components of moisture and dust.
10. Verify the insulation is intact on all external wires
and that all connections are secure. If bare wire is
evident, call a service technician.
Quarterly
NOTE: Disconnect power to the machine at its
source before performing the quarterly
maintenance procedures.
1. Tighten door hinges and fasteners, if necessary.
2. Using a Teflon-based spray lube, lubricate the
door lock by applying the spray to the door lock
pin while turning the door handle.
3. Tighten anchor bolts, if necessary.
4. Verify that the drain motor shield is in place and
secure, if so equipped.
5. Check all painted surfaces for exposed metal.
(Matching paint is available from the
manufacturer.)
● If bare metal is showing, paint with primer or
solvent-based paint.
● If rust appears, remove it with sandpaper or by
chemical means and then paint with primer or
solvent-based paint.
6. Clean customer-supplied steam filter, where
applicable. Refer to Figure 13.
a. Turn off steam supply and allow time for the
valve to cool.
b. Unscrew Cap.
c. Remove Element and clean.
d. Replace Element and Cap.
Figure 13
7. Check the bearing mounting bolts to make sure
they are torqued properly. Refer to Table 2 for
specifications.
H042I
1 Cap
2 Filter Element
Machine
Capacity
Bearing Torque
18-25 All 75 ft.-lbs.
27-60 All 105 ft.-lbs.
80 Front 200 ft.-lbs.
80 Rear 97 ft.-lbs.
Table 2
H042
I
1
2