Filter
Top Products
Operating instructions
26
Excessive foaming
during the main wash.
Probably too much detergent
was used
Dose detergent exactly in
accordance with the manu-
facturer’s instructions.
Water runs out from
under the washing
machine.
Threaded fitting on the
water inlet hose is leaking.
Tighten the water inlet hose
Drain hose is leaking.
Check drain hose and if
necessary replace.
Circulation pump cover is
not closed properly.
Close cover properly.
Washing is trapped in the
door.
Stop program, remove
washing from the door, start
a new program.
Softener is not washed
in, compartment w
for conditioner is full
of water.
Suction cap in the compart-
ment for conditioner is not
correctly positioned or is blo-
cked.
Clean detergent drawer,
place suction cap firmly in
position.
Appliance does not
spin, water in the
drum.
o (RINSE HOLD) selected. Deselect o (RINSE HOLD).
Washing is not spun
properly, water is still
visible in the drum.
Drain hose is kinked. Remove kink.
Maximum pumping height
(drain height 1m above the
floor on which the machine
is standing) exceeded.
Please contact customer ser-
vice who have a retrofit kit
for pumping to heights of
greater than 1m.
Circulation pump is blocked.
Switch off the machine and
unplug from the mains, clean
the circulation pump.
In the case of siphon con-
nection: siphon is blocked.
Clean siphon.
It is not possible to
open the door.
The door is locked for safety
reasons.
Wait 1-2 minutes after the
end of the program.
Rinse water is cloudy.
This is probably due to using
a detergent with a high sili-
cate content.
No negative impact on the
rinsing results, try using
liquid detergent.
Malfunction Possible Cause Remedy