AEG W 1020 Washer User Manual


 
Operating instructions
20
Washing Cycle Complete/Removing the Washing
The washing program normally ends with the final spin.
After a rinse hold:
After a rinse hold the water must first be pumped out or the washing
spun:
0 1. Release the o (RINSE HOLD) button.
2. Either turn the program selector clockwise to position 6 (SPIN), or posi-
tion 8 or 11 (SHORT SPIN)
(the washing is spun according to the selected program and the spin
speed set)
or
turn the program selector clockwise to v (PUMP OUT) (the water is
pumped out).
Once the program is finished:
3
For safety reasons, the door remains locked for 1-2 minutes after the
end of the program.
0 1. Open the door.
2. Remove the washing.
3. Press the M (ON/OFF) button.
The indicator extinguishes, the washing machine is switched off.
4. Close the water tap.
5. Pull out the detergent drawer slightly so that it can dry out. Leave the
door slightly ajar so that air can ciculate in the washing machine.
Important! If the washing machine is not to be used for a long period:
close the tap and isolate the washing machine from the mains.