Filter
Top Products
Operating instructions
30
Washing is not spun
properly, water is still
visible in the drum.
Fault code
(2 is dis-
played.
Drain hose is kinked. Remove kink.
Maximum pumping height
(drain height 1m above the
floor on which the machine
is standing) exceeded.
Please contact customer
service who have a retrofit
kit for pumping to heights of
greater than 1m.
Circulation pump is blocked.
Switch off the machine and
unplug from the mains, clean
the circulation pump.
In the case of siphon con-
nection: siphon is blocked.
Clean siphon.
Door cannot be opened
when the machine is
switched off.
The door is locked for safety
reasons (K/DOOR indicator
is off).
Wait until the K (DOOR)
indicator is green.
Remnants of detergent
are building up in the
detergent drawer.
Tap is not fully open. Open tap fully.
The sieve in the threaded fit-
ting on the water inlet hose
at the tap is blocked.
Clean sieve.
Sieve on threaded fitting for
the water inlet hose on the
machine is blocked.
Clean sieve.
Rinse water is cloudy.
The cause is probably a
detergent with a high silicate
content.
No negative impact on the
rinsing results, possibly use
liquid detergent.
When an additional
program button is
pressed, the corre-
sponding indicator
does not illuminate.
The additional program
selected cannot be combined
with the program set.
Make another choice.
Malfunction Possible Cause Remedy