Filter
Top Products
Instructions for use
18
Run a Washing Cycle
Brief Instructions
A washing cycle is run in the following steps:
0 1. Set the correct washing program:
– Set the program and temperature with the program selector
– Set any additional program(s)
2. If necessary, change the spin speed/select RINSE HOLD (GEEN CENTR.,
SANS ESSOR.).
3. Open the filling door and fill with washing.
4. Close the filling door.
5. Add washing detergent/care agent.
6. Start the washing program.
After the Washing Program Ends:
Attention! If the washing cycle ended with Rinse Hold, before opening
the filling door carry out PUMP (POMPEN, VIDANGE),
SPIN (CENTRIFUG., ESSORAGE) or SHORT SPIN (KORT CENTRIFUG.,
ESSOR. DELICAT).
7. Open the filling door and remove the washing.
8. Switch off the washing machine: Set the program selector to OFF
(UIT, ARRET).
Set the Washing Program
3
For a suitable program, the right temperature and possible additional
programs for the relevant washing type, refer to the ”Program Tables”.
0 1. Set the program selector to the
required washing program with
the required temperature.